Epson LX-810 Guide de l'utilisateur télécharger pdf (Page 93)

Options

With the roll paper holder, paper does not feed properly.

When you press the LOAD/EJECT button, the platen does not

rotate and paper does not feed.

You may be trying to feed paper while the printer is on

line (ON LINE light is on). Press the ON LINE button once to

set the printer off line; then feed the paper. After feeding

the paper, press the ON LINE button again to set the printer

on line.

When you press the LOAD/EJECT button, the platen rotates

but paper does not feed.

You may have pulled the paper release lever forward to the

continuous paper position. Push the paper-release lever

back to the single-sheet position.

The position of the roll paper may be wrong. Position the

paper roll so that the paper feeds off of the bottom of the

roll.

l The paper feed is crooked or the paper jams.

The roll paper holder may be installed incorrectly. Check

that the holes in the base fit onto the two corresponding

pegs at the bottom of the printer.

The shaft with the paper roll may not be properly mounted

on the roll paper holder. Make sure the shaft fits securely

onto the roll paper holder.

The position of the roll paper may be wrong. The roll

should be oriented so that paper feeds from the bottom.

The paper may be caught on the edge guides. Make sure

that the paper guide is installed over the paper and that the

edge guides are positioned at the center of the paper’s

width.

6-14 Troubleshooting

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 128 129

Pas de commentaire

Epson LX-810 Guide de l'utilisateur Page 93