Epson LX-810 Guide de l'utilisateur télécharger pdf (Page 23)

Testing the Printer

Before connecting your printer to a computer, use the built-in

self-test function to see that the printer is working properly.

Before running the self test, you need to connect your printer to

an electrical outlet.

Plugging in the printer

1. Make sure that the printer is turned off.

Check the label on the back of the printer to make sure the

power rating required by the printer matches that of your

electrical outlet.

CAUTION: If the rated voltage and your outlet voltage

do not match, contact your dealer for assistance. Do not

plug in the power cord.

If necessary, connect the power cord to the AC inlet on the

printer’s back panel.

Plug the power cord into a properly grounded electrical outlet.

Running the self test

The self test runs in draft or Near Letter Quality (NLQ) mode,

depending on which button you hold down as you turn on the

printer.

Make sure that the printer is turned off and then push the

paper release lever back to the single-sheet position.

While holding down the LINE FEED button (draft mode) or FORM

FEED button (NLQ mode), turn on the printer. The POWER and

PAPER OUT lights come on.

1-10

Setting Up the Printer

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 128 129

Pas de commentaire

Epson LX-810 Guide de l'utilisateur Page 23