Epson LX-810 Guide de l'utilisateur télécharger pdf (Page 47)

Setting

the DIP Switches

Short tear-off

When you are finished printing (when the printer receives a full

page of data or a form feed and then no more data for three

seconds), this feature automatically feeds the perforation of

continuous paper to the tear-off edge of the printer cover so that

you can tear off the last sheet. When you resume printing, the

paper feeds backward to the loading position. To use this feature,

set DIP switch 2-l to off and load continuous paper. Moving the

paper release lever to the single-sheet position disables the short

tear-off function.

Adjusting the short tear-off position

Make sure that the short tear-off feature is turned on and that

the paper is in the short tear-off position.

Press and hold the ON LINE button until the printer beeps

once and the ON LINE light begins blinking.

Press the FORM FEED button to feed the paper forward or the

LINE FEED button to feed it backward.

When you resume printing, the ON LINE light stops blinking and

the printer remembers the new tear-off position even after you

turn off the power.

Skip-over-perforation

If DIP switch 2-3 is on when you are using continuous paper, the

printer leaves a 25.4mm (one-inch) space between the last line on

one page and the first line on the next page so that the printer can

skip over the perforation. Because most application programs take

care of the top and bottom margins do not turn on skip-over-

perforation unless your program does not provide these margins.

3-8 Using the Printer

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 128 129

Pas de commentaire

Epson LX-810 Guide de l'utilisateur Page 47