Epson LX-810 Guide de l'utilisateur télécharger pdf (Page 30)

Using

Single

Sheets

Slide the paper down between the edge guides until it meets

resistance.

Press the LOAD/EJECT button once to load the paper.

Note: If the platen turns without loading the paper, remove the

paper and re-insert it more firmly. Then press the LOAD/EJECT

button again.

CAUTION: Never advance the paper using the platen

knob while the minter is turned on.

Press the ON LINE button to set the printer on line.

To eject the paper, set the printer off line (by pressing the ON LINE

button) and then press the FORM FEED button.

Printing multiple-page documents

When you print a document of more than one page using single-

sheet paper, you must reload paper at the end of each page. To

reload, first see that the printer is off line. (If the ON LINE light is

on, press the ON LINE button once to take the printer off line.)

Then load a new sheet by following steps 4, 5, and 6 above.

If your software has not been set up properly, the printer may

print too low on the second page of a document or print the last

few lines of one page on the next. If this happens, see Tips for

printing on single sheets at the beginning of this manual for

instructions on how to correct the problem.

Paper Handling 2-3

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 128 129

Pas de commentaire

Epson LX-810 Guide de l'utilisateur Page 30