Epson LX-810 Guide de l'utilisateur télécharger pdf (Page 92)

Options

l Several tines of space occur in the printout.

Skip-over-perforation may be set. Set DIP switch 2-3 to

off.

l Skip-over-perforation is set but does not work.

You may have changed the DIP switches with the power

on. To make new DIP switch settings effective, turn the

power off, then on again.

l Skip-over-perforation is set, but the skip has shifted from

the perforation, or the perforation does not fall in the center

of the skip.

The page length for one page of the continuous paper may

be set incorrectly. Set DIP switches 1-3 and l-4, or use

control codes ESC C or ESC C 0 to set the correct page

length.

The loading position of the paper may be too high or too

low. Use the microadjustment feature to reset the loading

position.

l When printing ends, the paper feeds abruptly, and as it

resumes printing, the paper feeds backward and comes off

the putt tractor sprockets.

You may have selected the short tear-off, which you cannot

use with the pull tractor. Be sure to set DIP switch 2-l on.

l When you press the LOAD/EJECT button to eject the paper,

the paper comes off the putt tractor sprockets.

When the paper release lever is in the continuous paper

position, the paper feeds backward to eject. When using the

pull tractor, press the FORM FEED button to feed the paper

forward.

Troubleshooting

6-13

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 128 129

Pas de commentaire

Epson LX-810 Guide de l'utilisateur Page 92