Epson Powerspan 2 Guide de l'utilisateur télécharger pdf (Page 73)

Loading an Alternate SCI File

To load an alternate SCI file and store it in the target

computer’s CMOS RAM, follow these steps:

1. Select Maintain system configuration diskette

from the EISA Configuration utility Main Menu.

2. Select Load a backup SCI file.

Select the alternate SCI file you want to load from the list of

SCI files displayed on the screen.

Exit and save the SCI file in the computer’s CMOS RAM.

Note

You can also load an alternate SC1 file by selecting Open

from the Maintain SCI files menu when you are using the

advanced configuration options. (See page 3-29.) This

method allows you to load the file while you are looking at

the View or edit details screen for another configuration.

However, the Open option erases the currently loaded

configuration before loading the new file.

Now the computer is configured according to the information

in the alternate SCI file.

Using Special Modes

You can run the EISA Configuration utility in various special

modes, including non-target modeling mode, by starting the

program with one of the two commands described in this

section. You can also use these commands to run the utility

from a hard disk that runs MS-DOS if you copy the necessary

files to the disk first.

Running the EISA Configuration Utility 3-31

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 218 219

Pas de commentaire

Epson Powerspan 2 Guide de l'utilisateur Page 73