Epson Powerspan 2 Guide de l'utilisateur télécharger pdf (Page 72)

If you run the EISA Configuration utility on a non-target

computer (an IBM AT compatible computer or another EPSON

EISA computer), you can create a file for the target computer.

Then you can transport the alternate SCI file to the target

computer, load it, and save it in that computer’s CMOS RAM.

To create an alternate SCI file, follow the guidelines in the next

section. To load an alternate SCI file when you need to use one,

see “Loading an Alternate SCI File” below.

Creating an Alternate SCI File

You can create an alternate SCI file using the following

methods:

Select Create a backup SCI file from the Maintain

system configuration diskette menu.

Select the Save as option from the Maintain SCI files

menu when you are using the advanced configuration

options.

Run the EISA Configuration utility in non-target modeling

mode and save the configuration you create to a backup

SCI file when you exit.

The program asks you to name the alternate SCI file you create.

Do not name the file SYSTEM.SCI; this is the name of your

current configuration file.

Run the EISA Configuration utility in non-target modeling

mode only when you are running the configuration program

on a non-target computer. This method protects you from

accidentally saving the configuration you create in that

computer’s CMOS RAM. See “Using Special Modes” for

instructions on using non-target modeling mode.

3-30 Running the EISA Configuration Utility

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 218 219

Pas de commentaire

Epson Powerspan 2 Guide de l'utilisateur Page 72