Epson Powerspan 2 Guide de l'utilisateur télécharger pdf (Page 184)

You want to change or delete the password.

See Chapter 4 for instructions on changing or deleting your

password.

You have forgotten the current power-on password.

If you have forgotten your power-on password and cannot use

your computer, follow these steps:

Turn off the computer, remove the system covers, and clear

the password by moving the main system board jumper

E0390 from position 1-2 to position 2-3. See Chapter 5 for

instructions on removing the covers and Chapter 6 for

instructions on changing the jumper setting.

Replace the computer’s cover. (See Chapter 5.)

If you do not have a hard disk, insert a bootable diskette in

drive A. Turn on the computer and allow it to load the

operating system.

Then turn off the computer, remove the covers, and enable

the password function by moving main system board

jumper E0390 from position 2-3 to position 1-2.

Replace the computer’s covers.

If you do not want to set a new password, you do not need

to do anything else. (When you turn on your computer, you

will not see the Enter password prompt.)

If you want to set a new password, go to step 6.

If you ran the SETUP program to configure your computer

the last time, go to step 7. If you ran the EISA Configuration

utility, go to step 8.

A-20 Troubleshooting

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 218 219

Pas de commentaire

Epson Powerspan 2 Guide de l'utilisateur Page 184