Epson Powerspan 2 Guide de l'utilisateur télécharger pdf (Page 39)

You must also run the EISA Configuration utility to fully enable yourbuilt-in

SCSl controller.

When you select Not Installed for the Video Type option, the display type

bits are configured for VGA.

If you change the refresh rate, you must press the reset button or turn

the computer off and then on again aftersaving your settings to reset the

rate.

The Offboard VGA/EGA Adapter Installed option settings do not affect

yourbuilt-in video controller. To enable ordisable thiscontroller, you must

set jumper E0290, See Chapter 6 for more information.

You cannot set Serial Port 1 and 2 to the same address. If you attempt to

do so, you see an error message.

7 The following I/O address ranges are never posted: 0000h to 00FFh, 0400h

to 04FFh, 0800h to 08FFh, and 0C00h to 0CFFh.

If you set the Onboard Video BIOS Mapping option to To C0000H, you

must set the Shadow C0000 to C7FFF option to Disabled to avoid a

memory conflict. If you set the Onboard Video BlOS Mapping option to

To E0000H, you must set the Shadow E0000 to E7FFF option to Disabled to

avoid a conflict. You must also set the SCSI BlOSMapping option so that

the SCSI BlOS does not conflict with any of these addresses.

Hard Disk Drive Types

The following table lists the types of IDE hard disk drives you

can use in your computer. Check this table and the manual that

came with your hard disk to find the correct type for the hard

disk drive(s) installed in your computer.

If the documentation for your hard disk drive includes only

the drive parameters and not a specific type number, search

through this list to find a type that matches your drive. If

none of the types match, select the user-defined drive types,

48 and 49, and set your own parameters using the Hard Drive n

option. See page 2-5. (You can configure user-defined drive

types 2 and 3 with the EISA Configuration utility only.)

Running the SETUP Program 2-13

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 218 219

Pas de commentaire

Epson Powerspan 2 Guide de l'utilisateur Page 39