Epson Powerspan 2 Guide de l'utilisateur télécharger pdf (Page 19)

Caution

Before you turn on the power to your system, you must be

sure the voltage selector switch is set to the appropriate

setting for the electrical power source in your location or

you will seriously damage your system.

To change the voltage selector switch setting, insert the tip of a

ball-point pen or a similar tool into the dimple on the switch.

Then slide the switch to the right to select 115 VAC or to the

left to select 230 VAC.

Installing Optional Equipment

Before you set up and connect your system components, you

may want to install any optional equipment you plan to use.

Chapters 6 and 7 give complete instructions for installing

options such as disk drives, memory modules, and option

cards.

Note

You may want to list the serial numbers and other important

information about the options you install in the “Equipment

Log” on page 1-11.

Note that the order in which you install option cards depends

on the type of cards you have. If you will be installing only ISA

option cards that did not come with their own configuration

(CFG) files, you should install the cards before you connect your

peripheral devices. Follow the instructions in your ISA card

manual to set the card’s switches or jumpers for your system.

You should also install any EISA cards before you connect

peripheral devices so your EISA Configuration utility can

automatically detect the cards and configure them correctly.

Setting Up Your System 1-5

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 218 219

Pas de commentaire

Epson Powerspan 2 Guide de l'utilisateur Page 19