Epson AL-M200 Series Guide de l'utilisateur télécharger pdf (Page 85)

5. Select the desired access point, and then press the button.

If the desired access point does not appear:

aSelect Manual Setup, and then press the

button.

b Enter the SSID, and then press the

button.

Use the

or button to enter the desired value, and press the or button to move a

cursor.

cSelect Infrastructure, and then press the

button.

d Select an encryption type, and then press the

button.

Important:

Be sure to use one of the supported encryption methods to protect your network traffic.

6. Enter the WEP key or pass phrase, and then press the

button.

Use the

or button to enter the desired value, and press the or button to move a cursor.

When the encryption type is WEP, select a transmit key after entering the WEP key.

7. Wait a few minutes until the printer restarts to establish the wireless network.

8. Print a System Settings page from the operator panel.

See “Printing and Checking the System Settings Page” on page 34.

9. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.

Note:

When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.

Using Ad Hoc Connection

To configure the wireless settings for an ad-hoc connection where the wireless devices communicate

directly with each other without an access point:

1. On the operator panel, press the

(Menu) button.

AL-M200 Series User’s Guide

Printer Connection and Software Installation 85

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 231 232

Pas de commentaire

Epson AL-M200 Series Guide de l'utilisateur Page 85