Epson RX700 Manuel d'instructions télécharger pdf (Page 73)

Checking and Cleaning and Print Head 73

5. Examine the nozzle check pattern you printed. Each staggered line should be

solid, with no gaps, as shown.

■ If your printout looks okay, you’re done. Press Back to return to the Setup

menu.

■ If you see any gaps, as shown below, press OK and follow the instructions

on the screen to clean the print head.

Cleaning the Print Head

Follow these steps to clean the print head so it can deliver ink properly. Print head

cleaning uses ink, so clean it only if quality declines.

Note:

You can also clean the print head using the printer software. Click the ? or Help button

on your printer settings screen for instructions on running the print head cleaning utility.

1. Make sure the Stylus Photo RX700 is turned on but not printing.

2. Press the

Setup button.

3. Use the u and d buttons to select

Head Cleaning.

4. Press the

OK button, then press OK again to start cleaning.

Cleaning takes about a minute, and you see a message on the RX700 screen

indicating that cleaning is in progress.

5. When cleaning finishes, press

OK to print a nozzle check pattern to check the

results (see page 72).

If you don’t see any improvement after cleaning three or four times, check the

solutions beginning on page 78. You can also turn the Stylus Photo RX700 off

and wait overnight—this allows any dried ink to soften—and then try cleaning

the print head again.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 97 98

Pas de commentaire

Epson RX700 Manuel d'instructions Page 73