Epson 1815p - PowerLite XGA LCD Projector Guide de l'utilisateur télécharger pdf (Page 36)

36 Presenting with the Remote Control

4. When done, press

Menu to exit the menu system.

Setting the Remote Control ID

The remote control’s default ID is zero. This lets you operate any

projector. To set it to operate a specific projector, follow these steps:

1. Point the remote control at the projector you want to be able to

operate.

2. Press and hold the

ID button on the remote control.

3. While holding the

ID button, press a numbered button on the

remote control (0 through 9) to select the desired ID. Select zero

to control all projectors, or select a number to match the ID of the

projector(s) you want to operate.

After setting the ID, you can check whether the remote control works

with a specific projector:

1. Point the remote control at the projector you want to check.

2. Press the

ID button on the remote control. You see a message on

the screen like one of these:

If the message says the remote control is “On,” then you can use

the remote control to operate that projector. If it says “Off,” then

you have to change the ID of the remote control and/or projector

before operation is possible.

note

If you’re using a remote

control ID other than the

default ID of zero, you have

to set the ID each time you

turn on the projector.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 203 204

Pas de commentaire

Epson 1815p - PowerLite XGA LCD Projector Guide de l'utilisateur Page 36