Epson Stylus Pro 7000 Print Engine Guide de l'utilisateur télécharger pdf (Page 50)

2-16

2-16 | Handling Paper

6. Press the

Pause

button. The print head moves and the paper feeds into

printing position automatically.

READY

appears on the control panel.

(Even if you don’t press

Pause

, the paper and printer will move into

printing position automatically after 10 seconds.)

7. Print your page. After it is finished, the sheet stays in the printer.

8. To remove your printout, hold the sheet while pressing the

Paper Feed (–)

button.

Printing on Heavy Stock

You can print on heavy stock up to B2 size (approximately 20 × 28 inches).

Follow these instructions when you print on card stock or other media more

than 0.5 mm thick.

1. Pull down the paper hammock to catch your printouts in front of the

printer (when you’re using the printer stand). Extend the paper guides

straight out in front of the printer to keep the stock from bending.

2. Press the

Paper Source

button repeatedly until the

Sheet

light

comes on.

3. Make sure the

Operate

light and

Pause

light are not flashing. Then

push the paper set lever all the way down.

4. Open the lower cover by pulling down on the handles.

5. Feed the stock into the paper slot until the bottom edge of the stock

rests behind the open lower cover.

Caution

To avoid damaging the

printer, never move the

paper set lever while the

Operate or Pause light is

flashing.

Note

You can’t run a cleaning

cycle when heavy stock is

loaded in the printer.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 146 147

Commentaires sur ces manuels

Pas de commentaire

Epson Stylus Pro 7000 Print Engine Guide de l'utilisateur Page 50

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Epson Stylus Pro 7000 Print Engine