Epson EPL-6000 Spécifications télécharger pdf (Page 158)

Error Messages

CHANGE DRUM

The drum unit may not be installed properly. Open the printer and

make sure the drum unit is seated properly in the basket. (Press

down simultaneously on the drum unit’s two green handles to make

sure the unit has clicked into place.)

Also, the drum replacement cartridge may not be installed. Be sure

to install a new drum replacement cartridge each time you replace

the drum unit.

If the message remains, the drum unit and the drum replacement

cartridge must be replaced. See the section on replacing the drum

unit in Chapter 6.

COVER OPEN

The printer cover is open. Close the cover and press the ON LINE

button to set the printer on line and begin normal printing.

ERROR 20

Not enough memory is available. Press the RESET/CONTINUE button

to continue printing. Your page may be printed as two or more

separate pages. This error can also be cleared by turning the printer

off and back on again. It may be necessary to simplify your print job

by downloading a smaller font, deleting some macros, or using a

lower resolution. You may also wish to purchase the optional 2MB

memory board available for this printer.

ERROR 21

The page is too complex to print. Press the RESET/CONTINUE button

to eject the page and clear the error. This error can also be cleared by

turning the printer off and back on again. Before you continue

printing, simplify the page you are trying to print.

Troubleshooting 7-3

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 218 219

Pas de commentaire

Epson EPL-6000 Spécifications Page 158