Epson EPL-6000 Spécifications télécharger pdf (Page 15)

Finding a Place for the Printer

Setting up your printer is a simple process that takes only a few

minutes. You need to find a location for your printer and install a

few parts. Then your printer will be ready to be connected to your

computer.

Before setting up your printer, you need to find a suitable place to

use it. Be sure to keep the following points in mind when selecting a

place for your printer:

Place the printer on a flat, stable surface.

Place the printer close enough to the computer or workstation

for its cable to reach.

Your printer is equipped with four rubber feet. Be sure that your

printer stand or desktop is large enough to accommodate all

four feet.

Use a grounded outlet-one that has three holes to match the

power plug on the printer. Do not use an adapter plug.

Leave adequate room around the printer to allow easy printer

operation and maintenance. You need to locate a space that is 35

inches (889 mm) wide and 24 inches (610 mm) deep. When you

install the printer in this space, you should make sure there is

sufficient room on each side of the printer. See the following

diagram for details.

Note: If you plan to install the face-up output tray, you need a

space that is 44 inches (1118 mm) wide and 24 inches (610

mm) deep. Within this area, you need 13 inches (330 mm) of

flat, unobstructed space to the left of the printer, rather than

the 5 inches (127 mm) shown in the diagram below. There

should be at least 2 inches (50 mm) of space to the left of the

tray after it is installed.

1-2

Setting Up the Printer

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 218 219

Pas de commentaire

Epson EPL-6000 Spécifications Page 15