Epson 1420Wi Guide d'installation télécharger pdf (Page 21)

English

When all of the dots have disappeared, press the button on the remote control and then go to

step 13.

If any dots remain (as shown below), do the following:

• Remove any obstacles from around the projected screen. When you are finished, press the or

button on the remote control and repeat step 12.

• If the dots still remain after removing obstacles, turn the adjustment dials about a quarter turn

counterclockwise. Next, press the or button on the remote control and repeat step 12.

• If the dots still remain or there are obstacles that cannot be removed, such as whiteboard trays or

frames, go to step 13.

13. If there is an obstacle that cannot be removed, such as a whiteboard tray or frame, remove the tape

from the back of the supplied infrared deflectors and stick them to the screen so that the laser is not

reflected by the obstacle.

Make sure to stick the deflectors between the dots and the obstacle and adjust the number of

deflectors according to the number of dots.

After placing the infrared deflectors, press the or button on the remote control, and then

repeat step 12.

If the dots do not disappear even after attaching the infrared deflectors, turn the adjustment dials

about a quarter turn counterclockwise. Next, press the or button on the remote control,

and then repeat step 12 again.

If the dots do not disappear even after performing the above procedures, contact Epson.

❏ Do not remove an infrared deflector once it has been stuck in place.

❏ Do not stick tape or place anything on the infrared deflectors. The deflectors will

not function properly if anything is placed on them.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Pas de commentaire

Epson 1420Wi Guide d'installation Page 21