Epson 1420Wi Guide d'installation télécharger pdf (Page 23)

English

5 Installing the Control Pad

You must install the control pad on the same surface as the projector, within the range specified in the

installation instructions. You can use batteries to power the control pad, or the optional remote control cable

set (model ELPKC28, part number V12H005C28).

You must have completed the steps in “Installing the Projector” in the Installation Guide before installing the

Control Pad.

Follow the steps below to install the Control Pad and connect to the projector.

Check the installation location

The Control Pad must be installed in the area specified in the diagram below.

Make sure there is enough space surrounding the Control Pad. Because the top panel

opens from the left, there must be additional space to the left of the Control Pad.

The Control Pad should only be connected to the BrightLink Pro 1420Wi/1430Wi. Do not

connect the Control Pad to any other projectors.

Caution

68.9 in.

(1.75 m)

35.4 in.

(0.9 m)

27.6 in.

(0.7 m)

13.8 in.

(0.35 m)

9.8 in.

(0.25 m)

39.3 in. (1.0 m)

59.0 in. (1.5 m)

78.7 in. (2.0 m)

78.7 in.

(2.0 m)

60-inch

image

100-inch

image

Remote control

light emitting areas

2 in. (50 mm)

2 in

(50 mm)

2 in. (50 mm)

3.9 in

(100 mm)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Pas de commentaire

Epson 1420Wi Guide d'installation Page 23