Rev. D OS and Drivers 2-47
IR-700 Technical Reference Guide
Setup procedure
Prepare the following before starting the setup of Windows 2000.
1. Startup disk
• Create the startup disk using the following procedure.
1. Prepare a blank floppy disk.
2. Copy all files in /WIN2K/SATARAID/Driver folder of the driver CD to the floppy disk.
2. CD/DVD-ROM drive
3. FD
drive
drive drive
drive
• This is necessary for reading the startup disk.
Note:
When installing Windows 2000, be sure to connect the CD/DVD-ROM drive and FD drive to the USB
connector on the side. It may cause malfunction if they are connected to the USB at the rear.
Windows 2000 is set up by using the following procedure:
1. Connect the keyboard and mouse to the IR-700.
2. Connect the CD/DVD-ROM drive and FD drive to the IR-700.
3. Insert the CD-ROM of Windows 2000 in the CD/DVD-ROM drive and boot up the system.
Other software Installation
Install utilities such as serial driver, 28-key, MSR, and 60-key from backup
folder if necessary.
Setting of Power Management
Set the procedure of return from the standby mode.
Setting of RAID
If there are 2 installed HDDs and you are going to use a RAID system, set it
up.
Commentaires sur ces manuels