7-22 How to Use RAID Rev. D
Failures and Determining the Failed HDD
This section describes corrective actions when an error occurs due to hard disk failure.
Errors that can be Detected During the System’s Start-up Process
The RAID BIOS checks the hard disk drives during the system’s start-up process.And the check
result appears on the screen as shown below.
When the Hard Disks are found to be Normal
When a RAID Error is Detected
The above check result indicates that one of the two hard disk drives is at fault.
In such case, press Ctrl+S, or F4 key to start RAID BIOS.
Sil 3512A SATARaid BIOS Version 4.3.47
Copyright (C) 1997-2004 Silicon Image, IncÅD
Press <Ctrl+S> or F4 to enter RAID utility
0 SAMSUNG SP1213C 114498MB
1 SAMSUNG SP1213C 114498MB
Sil 3512A SATARaid BIOS Version 4.3.47
Copyright (C) 1997-2004 Silicon Image, IncÅD
Press <Ctrl+S> or F4 to enter RAID utility
0 SAMSUNG SP1213C 114498MB
Sil Mirrored set SAMSUNG SP1213C
RAID1 set is in Critical Status.
Press any key to enter Configuration Utility.
Commentaires sur ces manuels