Epson IR-320 Spécifications Page 374

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 386
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 373
A-6 Hardware Specifications Rev. D
The PCI cards within the dimensional range as shown in the following figure can be mounted.
Printer
EPSON thermal printer TM-T88IIIX is installed. It is an advanced and reliable printer.
The printer is controlled by Windows driver APD (EPSON Advanced Printer Driver), OPOS,
ESC/POS command, etc.
For more information about the printer, refer to [TM-T88IIIX Technical Reference Manual].
Drawer
It is connected on the drawer connector of the printer unit, and controlled via the printer. A
three-terminal regulator is built in the printer for current limiting.
Ethernet Controller
The Ethernet controller is built in the Chipset (Intel ICH4 ). This enables operation at 10 Mbps
and 100 Mbps and wakeup from the LAN.
To enable the wakeup, set Resume by OnBoard LAN to Enable with the BIOS Power menu.
The operating status of LAN can be confirmed by the LED of the Ethernet connector.
The controller can be disabled by setting OnBoard LAN of the Chipset menu in the BIOS to
Disabled. (Refer to Chapter [BIOS] for more information.)
The MAC address specific to each controller is described on the seal attached to the main board
(remove the side panel which is on the left side of the unit). For Windows 2000/XP/WEPOS, the
MAC address can be obtained by using the following command:
ipconfig/all
167.64mm{4.8} or less
106.68mm
{4.18} or
less
Vue de la page 373
1 2 ... 369 370 371 372 373 374 375 376 377 378 379 ... 385 386

Commentaires sur ces manuels

Pas de commentaire