Epson Stylus Color IIs Guide de l'utilisateur télécharger pdf (Page 67)

Calibrating the Printer

Your printer has been calibrated at the factory so that vertical

lines in your text and graphics are properly aligned. If you

notice misaligned images in printouts, however, you can

calibrate the printer with the Bi-D Calibration Utility. You may

need to do this after moving the printer to a new location, for

example.

You can copy the Bi-D Calibration Utility from the Windows

printer driver diskette to your hard disk, or run it from the

diskette when needed. You calibrate the printer twice—once

with the monochrome print head installed and once with the

color print head installed. Follow these steps:

1. If you did not install the Bi-D Calibration Utility on your

hard disk, insert the driver diskette in your computer’s

diskette drive.

2. Make sure Windows is running.

3. To start the Bi-D Calibration Utility using Windows 3.1

Program Manager, choose Run from the File menu. The

Run dialog box appears.

To start it using Windows 95, click Start; then choose Run.

4. In the Command Line box (Windows 3.1) or the Open field

(Windows 95) type the drive and directory name where the

utility is located. For example, type A:CALIBRAT (or

C:\

directory

\CALIBRAT if it is on your hard disk). Then

choose OK.

5. When you see the Calibration Utility screen, verify that

Stylus COLOR IIs is selected as the printer for calibration. If

it isn’t, use ↑ or ↓ to select it.

Also make sure Print Calibration Pattern is selected at the

bottom of the screen. (Use the Tab key to move down and ↑

to select it, if necessary.)

Hudson User’s Guide

A5 size Chapter 3

10-28-95 DR, pass 2-Rev1

Maintenance 3-15

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 113 114

Pas de commentaire

Epson Stylus Color IIs Guide de l'utilisateur Page 67