Epson Stylus Color IIs Guide de l'utilisateur télécharger pdf (Page 66)

Transporting the Printer

If you need to transport your printer, carefully repack it in the

original box and packing materials as follows:

1. Turn off the printer, if you have not already done so.

2. Open the printer cover and make sure that the print head

is locked in the far right position. If it isn’t, turn on the

printer, wait about 10 seconds, and turn it off.

Caution:

Do not remove the ink cartridges when transporting the

printer. Transporting the printer without the cartridges

installed can damage the printer.

3. Use a strong adhesive tape to secure the print head to the

side of the printer.

4. Unplug the power cord from the electrical outlet.

5. Disconnect the interface cable from the printer.

6. Remove any paper from the sheet feeder and remove the

paper support.

7. Push in the output tray extension and rotate the output tray

until it is beneath the printer.

8. Attach the protective materials to the printer. See the Notice

Sheet that was packed with the printer.

9. Repack the printer and attachments in the original box.

Be sure to keep the printer flat as you transport it. If you notice

problems with the printed image after transporting the printer,

clean the print head as described on page 3-2. If the printed

image is misaligned, calibrate the printer as described in the

next section.

Hudson User’s Guide

A5 size Chapter 3

10-28-95 DR, pass 2-Rev1

3-14 Maintenance

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 113 114

Pas de commentaire

Epson Stylus Color IIs Guide de l'utilisateur Page 66