Epson LX-86TM Spécifications télécharger pdf (Page 86)

REV.-A

3. Remove the five screws securing the

ROC

filter unit to the base plate.

The screws are as follows:

1 X

C.B.O.

(M4 X 8)

1 X C. T. B.S.(O)

(M4 X 8)

C.T.B.

(M4 X

1 X C. T. P.S.(O) (M3 X 6)

4. Remove the

ROC

filter unit (including the AC cable (120 V), AC inlet (220/240 V), and power switch).

4.2.4 Removal of Printer Mechanism

This section describes the platen unit, paper guide, and printer mechanism removal. Before removing

the printer mechanism, remove the platen unit and the paper guide so that the printer mechanism can

be removed quickly and easily.

Fig. 4-7. Printer Mechanism Removal

4.2.4.1 Removal of Platen Unit and Paper Guide (Figures 4-8 through 4-9)

1. Remove the upper case. (Refer to Section 4.2. 1.1)

2. Turn the shaft holders at the left and right sides of the platen unit as shown

in Figure 4-8, and lift

the platen unit to remove it.

a. Push the shaft holder outward using a screwdriver.

b. Turn the shaft holder counterclockwise.

Frame

(Left Side)

ten

‘Shaft

Holder

Fig. 4-8. Platen Unit Removal

4-7

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 141 142

Pas de commentaire

Epson LX-86TM Spécifications Page 86