Epson EMP-750 Guide de l'utilisateur télécharger pdf (Page 43)

Adjusting the Screen Image

User’s Guide

PROCEDURE

While pulling the foot adjust lever at the front of the

projector, lift up the front of the projector to extend the

front adjustable foot.

Extend the front adjustable foot until the desired angle is obtained,

and then release the foot adjust lever.

To retract the front adjustable foot, gently push down on the projector

while pulling the foot adjust lever.

If you tilt the projector up, keystone distortion will occur in the projected

screen. However, the projector is equipped with an automatic keystone

correction function that can automatically correct this keystone distortion

on the screen. Automatic keystone correction is carried out approximately

one second after the projector is tilted vertically while the power is on.

Foot adjust lever (Front)

TIP

When the projector is tilting horizontally, turn the left rear adjustable

foot until the projection is level. When the projector is tilted

horizontally, the correction may not be carried out correctly. sp.42

Extend Retract

Rear

adjustable foot

TIP

•Automatic keystone correction is not carried out when the

"Projection" command in the "Extended" menu is set to "Front".

•If you would like to make further fine adjustments after automatic

keystone correction has been carried out, press the [ ] and [ ]

buttons on the projector's control panel. sp.43

•When keystone correction is carried out, the projected image will

become smaller.

•If the text part of the image is blurred after keystone correction is

carried out, decrease the sharpness setting.

p.56, p.58

•If automatic keystone correction is not required, set "Auto

Keystone" in the "Setting" menu to "OFF". sp.62

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 120 121

Pas de commentaire

Epson EMP-750 Guide de l'utilisateur Page 43