Epson ActionPC 2000 Guide de l'utilisateur télécharger pdf (Page 83)

Remove the two screws securing the drive on each side.

Reach behind the drive and gently push it to the front of the

bay; then pull it out of the slot.

Once you have removed the drive, replace the faceplate by

inserting one side of the plate, then gently pressing on the

other side until it snaps into place.

Replace the diskette drive and mounting bracket and

reconnect the cables. See page 4-8 for instructions.

Post-installation Procedures

After you install or remove your drive(s) and replace the cover

on your computer, you need to run the SETUP program to

define the correct configuration for your newly installed drive.

See Chapter 1 for instructions.

4-22

Installing and Removing Drives

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 128 129

Pas de commentaire

Epson ActionPC 2000 Guide de l'utilisateur Page 83