Epson ActionPC 2000 Guide de l'utilisateur télécharger pdf (Page 61)

Position the coprocessor over the socket as shown below.

Align the notched corner of the coprocessor (marked with a

dot) over the bevelled corner in the socket. Then gently

push it straight into the socket, pressing evenly on all sides.

bevelled

corner

Replace any option cards you removed. See page 3-13.

Caution

Removing a coprocessor chip requires a special tool. To

remove a chip, take your computer to an Authorized EPSON

Servicer.

Post-installation Procedures

After you install or remove options such as memory modules

or a math coprocessor, you must run SETUP to update the

computer’s configuration. See Chapter 1 for instructions.

Additionally, you may need to add some commands to your

configuration files. See your operating system manual and the

manual that came with your optional equipment.

3-20

Installing and Removing Options

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 128 129

Pas de commentaire

Epson ActionPC 2000 Guide de l'utilisateur Page 61