Epson DS-560 Guide de l'utilisateur télécharger pdf (Page 36)

9. Open the Device menu and select Quit.

10. Turn off the scanner.

11. Disconnect the computer or device's direct Wi-Fi connection, then connect the computer or device to

the router or access point.

12. Set the connection mode switch on the scanner to Wi-Fi.

13. Turn on the scanner.

When the Status light on the scanner stays on, the connection is established.

14. Set up network scanning on your computer.

Parent topic: Connecting to an Existing Wi-Fi Network

Related tasks

Setting Up Network Scanning

You can set up network scanning using one of these methods:

• through a direct connection to your scanner

• through a connection with the optional Epson Network Interface Unit

Note: Make a note of the IP address or host name of the Network Interface Unit or scanner so you can

enter it in these steps.

1. Do one of the following:

• Manually configure your scanner to connect to your network

• Connect the Epson Network Interface Unit to your scanner and verify they are working properly.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 111 112

Pas de commentaire

Epson DS-560 Guide de l'utilisateur Page 36