Epson TWAIN PRO Network Guide d'installation télécharger pdf (Page 32)

Setting Up the Scanner

2-13

Connecting the scanner

Connect the scanner to your computer or to another SCSI device

as described below.

Note:

The types of connectors needed on the SCSI interface cable varies

depending on the maker of your SCSI device and SCSI interface board.

1. Make sure the scanner, computer, and all other SCSI devices

are turned off and unplugged from the power source.

Caution:

Do not connect the scanner to the computer or other devices

while they are turned on as damage may occur.

2. Connect one end of the interface cable to one of the scanner

SCSI connectors until the locks on both sides snap in.

Note:

❏

To connect the scanner to a SCSI device other than the

computer, the length of cable in the daisy chain must not exceed

6 meters; otherwise the system may not work properly.

❏

To connect the scanner to a PC using SCSI-2, the length of the

cable must not exceed 3 meters.

❏

Make sure no other interface is used.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 116 117

Pas de commentaire

Epson TWAIN PRO Network Guide d'installation Page 32