Epson CMD-2260 (CD-ROM) Informations techniques télécharger pdf (Page 45)

__________________________________________________

Blastware Compliance Module

Blastware Operator Manual 4–21

35. Under the General tab, select “Use the following IP address:” and input an IP Address.

The first three sets of numbers (in this example, 192.168.1) must match the Static IP

Address that was provided by the Internet Service Provider. The last number must vary,

but cannot be “255” as that is reserved for another protocol. If supplied, or a WAN, enter

the Static IP Mask number into the Subnet Mask value field, otherwise use

255.255.255.0. Below is an example of a Static IP Address and a LAN Subnet Mask:

36. Start Blastware. Within Blastware, select the Unit > Communications menu. The

Communications Setup dialog appears.

37. Select the Series IV Ethernet communications option.

38. Select the Static IP Address option. The value field to the right will become available

for editing. Enter the Static IP Address supplied by the Internet Service Provider – it

must match the number entered into the Static IP Address field on the unit.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 223 224

Pas de commentaire

Epson CMD-2260 (CD-ROM) Informations techniques Page 45