Epson PowerLite 713c Guide de l'utilisateur télécharger pdf (Page 67)

Solving Problems

Refer to the following table for a complete description of the projector’s status lights and their

meaning.

Status lights

Light Status Description

orange The projector is in sleep mode. You can unplug it or press the Power

button to turn it on.

flashing green The projector is warming up. Wait for the image to appear.

green The projector is operating normally.

flashing orange The projector is cooling down. You can’t turn it back on (and you

should not unplug it) until the light stops flashing and remains orange.

red Power is cut off because of an internal problem. Remove the power

cord and contact EPSON for help.

red The lamp is burned out. Replace it as described on page 54.

flashing orange The lamp is almost burned out. Replace it as described on page 54.

flashing red There is a problem with the lamp, power supply, fan, or circuit. If

necessary, replace the lamp as described on page 54.

flashing orange The projector is too hot. Make sure the temperature surrounding the

projector does not exceed 104

F and there is plenty of space around

and under the projector for ventilation. Clean the air filter, if necessary.

See page 53 for instructions.

red The projector is overheating, which turns off the lamp automatically.

Let it cool for a few minutes, then turn it back on. Make sure there is

plenty of space around and under the projector for ventilation. If it

continues to overheat, you may need to change the air filter. See

page 53 for instructions.

flashing red There is a problem with the cooling fan or temperature sensor. Turn

off the projector and unplug it. Contact EPSON for help.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 104 105

Pas de commentaire

Epson PowerLite 713c Guide de l'utilisateur Page 67