Epson 410 Manuel d'utilisateur télécharger pdf (Page 49)

Chapter 5 Printer Commands

))))))))))))))))))))))))))))))))))))))))))))

410 Operators Manual 43

^A ^D COMMAND

XX 75 Load Label Count: Tells the printer to print a batch of labels using the serial

number function if enabled. Can be used in conjunction with load copies count

(^D73). The batch of labels will be printed when a ^D3 is executed. Therefore, this

must precede a ^D3 command. The only difference between this command and

^D73 is in the ability of this command to increment and decrement sequential

numbers in the batch. See section 5.3 for more information. Example usage:

^A20^D74^D3<CR> - Prints 20 serial number labels.

XXX 76 Load Delay Time Between Printed Labels: Delays the printing between labels

in a batch. Preceded by ^A which contains the wait in 1/10ths of a second

increments. The maximum value is 650. Example usage: ^A10^D76<CR> -

introduces a one second delay between printed labels.

5.3.3 AUTO-SIZING and VALID GAP COMMANDS

The auto-size feature gives important format file values for the label header. These

values are:

LSY - Label height

GAP - Distance between labels

AGD - Steps until activating gap detector

SPG - Steps past gap

^D91Value - Sets transmissive properties of stock. See ^D91 definition later in

this section. This value is obtained from auto-sizing and should

be inserted as the ^A value associated with the ^D91 command.

This must be done whenever stock is changed.

When auto-size is executed, a sample of approximately 10 labels will run through the

printer. The printer averages the values it receives from these labels.

To auto-size labels that use a black line instead of a gap, first execute a ^A1^D47<CR> to

put the unit in black line mode.

To auto-size blow-hole stock, set software dip switch 4 for blow-hole stock (see section

5.3.1) and then auto-size.

There is also a power-up auto-size feature as defined in section 5.3.3, ^D24.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 103 104

Pas de commentaire

Epson 410 Manuel d'utilisateur Page 49