Epson T3000 Guide d'installation

Setup Guide Printed in USACPD-38235Epson® SureColor® T-Series Epson® SureColor® T-Series CPD38235_Opera_SG_E.indd 1 10/16/12 10:24:05 AM

8 | Attaching the Paper Basket5. Attach the shorter arm to the inside of the basket holder on the left side of the printer. Use two nuts to hold the a

Attaching the Paper Basket | 98.Slide the pole through the basket cloth until it comes out the other end. The small hole in the cloth will be on the r

10 | Attaching the Paper Basket11. Use two nuts and two bolts to fasten the arm in place.12. On the back side of the printer, pull the paper basket up

Connecting the Power Cord | 1114.On the front side of the printer, slide the basket’s fabric all the way to the ends of the rounded pole as shown.Conn

12 | Installing Ink CartridgesInstalling Ink CartridgesUse the ink cartridges that came with your printer for initial ink charging. During the initial

Loading Roll Paper | 134.Close the ink cover and wait for the ink to charge. The ink charging process takes about 22 minutes.Caution: Do not turn off

14 | Loading Roll Paper1. Open the roll paper cover.2. Raise the roll lock lever.3. Place the roll on top of the printer.

Loading Roll Paper | 154.If necessary, adjust the roll media adapters to fit the core size of the roll paper.5. Release the tension lever on both adap

16 | Loading Roll Paper8. Slide the roll paper all the way to the right until it lines up with the adapter guides.9. Press the button on the control

Loading Roll Paper | 1711.Pull the paper straight through until the leading edge reaches the front of the printer.12. Lower the roll lock lever.13. Fo

Control PanelBack buttonMenu buttonLoad/remove paper buttonPower button and lightPause/cancel buttonMaintenance buttonMedia feed button/cut buttonLCD

18 | Loading Roll Paper14. Close the roll paper cover.15. Check the message on the control panel.• If the paper type was automatically detected, the p

Performing a Test Print | 19Performing a Test PrintYou can print a nozzle check from the control panel and examine it to determine whether any nozzles

20 | Aligning the Print HeadAligning the Print HeadFollow the steps below to align the print head using the printer’s control panel. Make sure the pap

Updating Your Printer Firmware | 21To connect to a network hub or directly to your computer’s network interface, you need a standard RJ-45 CAT-6 netwo

22 | Updating the Firmware3. Click Acquire Latest Information to automatically download the latest firmware version for your printer from the internet

EPSON and SureColor are registered trademarks, and EPSON Exceed Your Vision is a registered logomark of Seiko Epson Corporation.General Notice: Other

ContentsUnpacking and Assembling the Printer ...2Assemb

2 | Unpacking and Assembling the PrinterUnpacking and Assembling the PrinterNote: Unless otherwise indicated, the illustrations in this manual show th

Assembling the Stand | 3The following items are included with your printer:Assembling the Stand1. Unpack the stand and make sure you have all of these

4 | Assembling the Stand2. Slide the horizontal strut into both of the legs as shown.3. Use the long end of the hex wrench to tighten the pre-placed s

Mounting the Printer on the Stand | 5Mounting the Printer on the StandYou need at least two people (SureColor T3000) or four people (SureColor T5000/T

6 | Attaching the Paper Basket2. Attach the printer to the stand using three bolts.Attaching the Paper BasketThe paper basket is a cloth sheet that at

Attaching the Paper Basket | 72.Attach the stack guides to the bottom of the printer. Make sure each guide snaps securly into place.3. Insert a plasti