Epson FX-980 Spécifications télécharger pdf (Page 12)

EPSON FX-980

12 -

EPSON FX-980

4/99

Using the Front Push Tractor

To use the front push tractor, load continuous paper in the

front slot. For more information on when to use the front push

tractor, see “Available Paper Paths” on page 7.

Note:

The tractors are installed in the front push and rear push positions

when the printer is shipped. The rear tractor cannot be removed.

Installing the tractor in the front push position

If a tractor is installed in the front push position, skip to the

next section, “Loading paper onto the front push tractor.”

If a tractor is installed in the pull position, you need to remove

it and install the paper tension unit. To install the tractor in the

front push position, follow these steps:

1. Make sure the printer is turned off. Open the front paper

guide by (➀)pulling the tab at the center of the guide. Then

remove the guide by grasping both sides (➁) and pulling it

straight out of the printer.

2. Insert the tractor into the mounting slots (➀) and press

down both ends of the tractor (➁) to make sure that it is

firmly seated.

You are now ready to load continuous paper onto the front

push tractor as described in the next section.

Loading paper onto the front push tractor

To load paper onto the front push tractor, follow these steps:

1. Make sure the printer is turned off. Open the front paper

guide by pulling the tab at the center of the guide. Then

remove the guide by grasping both sides and pulling it

straight out of the printer. Check that the tractor is installed

in the front push position.

2. Set the paper release lever to the front push tractor position.

Then set the paper thickness lever to accommodate your

paper thickness.

3. Release the left and right sprockets by pushing the sprocket

lock levers backward.

tab

front push

tractor position

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Pas de commentaire

Epson FX-980 Spécifications Page 12