Epson F2000 Manuel d'utilisateur télécharger pdf (Page 16)

How To 16

1. Click Start, highlight Control Panel, and then click Network and Internet

Connections. Select Network Connections.

2. Under LAN or High-Speed Internet, click the Local Area Connection icon.

3. Under Network Tasks, click Change settings of this connection.

4. Check if the following necessary components are in the list.

The following table lists the components required for configuring the network interface

with EpsonNet Config.

The following table lists the components required for network printing.

5. Double-click Internet Protocol (TCP/IP) on the Local Area Connection Properties

dialog box to open the Internet Protocols (TCP/IP) Properties dialog box. Set the IP

address, the subnet mask, etc. and then click OK.

6. Restart the computer.

The necessary components are now installed. Go to the section “Setting Up the Network

Interface” on page 18.

EpsonNet Config’s setting screens Necessary components

TCP/IP, WSD, UPnP, Bonjour Internet Protocol (TCP/IP)

Printing method Necessary components

TCP/IP printing Internet Protocol (TCP/IP)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Epson F2000 Manuel d'utilisateur Page 16