Epson EMP-TW2000 Guide de l'utilisateur télécharger pdf (Page 15)

Installing the Projector

Preparing the Remote Control

Inserting batteries into the remote control

The remote control is not supplied with batteries already inserted. Insert the accessory batteries

before using the remote control.

If delays in the responsiveness of the remote control occur or if it does not operate

after it has been used for some time, it probably means that the batteries are

becoming flat. If this happens, replace the batteries with two new batteries. Use two

new AA batteries as replacement batteries.

Remove the battery cover.

Insert the batteries.

Install the battery cover.

While pressing the knob, lift up.

Insert the tab.

Press down until the battery

cover clicks into place.

Check the (+) and (-)

indications inside the

battery compartment and

insert the batteries so that

they face correctly.

TIP

Using the remote control

Operating range (horizontal)

Operating range (vertical)

Remote control light-receiving area

Operating distance

Approx.10m

Remote control

light-emitting area

Operating distance

Approx.10m

Operating distance

Approx.10m

Approx.30

Approx.30 Approx.30 Approx.30

Approx.30

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 58 59

Pas de commentaire

Epson EMP-TW2000 Guide de l'utilisateur Page 15