Epson PowerLite 1825 Manuel d'utilisateur télécharger pdf

INSTALLATION

HANDBOOK

Lamp and Status Information

Epson PowerLite 1825

Replacing the Lamp and Air Filter

The life span of the projection lamp is about 2,500 hours if

Brightness Control in the Settings menu is set to High

(default), and 3,000 hours if

Brightness Control is set to Low.

Note: When you get a replacement lamp for your projector, you

should replace the filter. Turn off this product when not in use to

prolong the life of the projector.

It is time to replace the lamp when:

The projected image gets darker or starts to deteriorate.

The message Replace the lamp appears on the screen when

the lamp comes on and the lamp warning light flashes

orange. To maintain projector brightness and image quality,

replace the lamp as soon as possible.

The lamp warning light flashes red (the lamp is burnt

out).

To obtain a new lamp, contact your dealer or call Epson at

800-GO-EPSON (800-463-7766). Request part number

V13H010L40.

Lamp

warning

light

Follow these steps to replace the lamp and air filter:

1. Turn off the projector and unplug the power cord.

2. Let the projector cool for at least an hour (if it has been on).

The lamp is extremely hot immediately after use.

Warning: Let the lamp cool fully before replacing it. In the

unlikely event that the lamp has broken, small glass fragments

may be present and should be removed carefully to avoid injury.

If the lamp is used after the replacement period has passed, the

possibility that the lamp may break increases. When a lamp

replacement message appears, replace the lamp with a new one

as soon as possible, even if it is still working.

3. Loosen (but don’t remove) the lamp cover screw. Then slide

the lamp cover to the side and lift it off the projector.

4. Loosen the two screws holding the lamp in place.

5. Hold the lamp as shown and pull it straight out.

Note: The lamp(s) in this product contain mercury. Please

consult your state and local regulations regarding disposal or

recycling. Do not put in the trash.

Loosen, but don’t

remove these screws

6. Gently insert the new lamp. (If it doesn’t fit easily, make

sure it is facing the right way.)

7. Once the lamp is fully inserted, tighten its screws.

8. Replace the lamp cover, then tighten its screw.

9. Slide the air filter out and remove it.

10. Slide in the new air filter until it clicks in place.

11. Reset the lamp timer as described in the next section.

1 2

INSTALLATION 1

Résumé du contenu

Page 1 - INSTALLATION

INSTALLATIONHANDBOOKLamp and Status Information Epson PowerLite 1825Replacing the Lamp and Air FilterThe life span of the projection lamp is about 2,5

Page 2

INSTALLATIONHANDBOOKLamp and Status Information Epson PowerLite 1825Resetting the Lamp TimerAfter you replace the lamp, you need to reset the lamp tim