Epson LS47P2 Manuel d'utilisateur télécharger pdf (Page 34)

34 Setting Up the TV

Operating the Remote Control

Aim the remote control at the front of the TV, within about a 25° horizontal angle to the left

or right and a 15° vertical angle up or down from the remote receiver.

Make sure the room lighting is not too bright and not shining directly on the remote control

or the TV receiver window. Keep the transmitter area on the top of the remote and the TV

receiver window clean.

To turn off the remote control’s beeping sound, hold down the Menu button for 2 seconds,

until the remote control light stops flashing. Then press the Volume down button. (To turn

it back on, hold down the Menu button for 2 seconds, until the remote control light stops

flashing. Then press the Volume up button.)

Remote Control Information

The TV may not respond to remote control commands under the following conditions:

• There is an object between the remote control IR emitter and the IR receiver on the TV.

• Ambient light is too bright.

• Certain types of fluorescent lighting are used.

• A strong light source shines into the IR receiver.

• Other equipment that emits infrared energy, such as a radiant room heater, is in the room.

If these conditions cause problems for your TV’s remote control, try the following:

• The remote control’s batteries may be low on power; replace them.

• Dim the ambient lighting and/or turn off any fluorescent lights.

• Close any window coverings and/or move the TV out of direct sunlight.

• Turn off other equipment that emits infrared energy.

Receiver

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 135 136

Pas de commentaire

Epson LS47P2 Manuel d'utilisateur Page 34