Epson TM-U925 Manuel d'utilisateur télécharger pdf (Page 30)

2-2 Using the Printer

SLIP FEED

You cannot load slip paper using this button. Slip paper can be

loaded only by selecting slip paper with a command and then

inserting the paper. When the printer is in the slip paper mode (the

SLIP light is on or blinking) and slip paper is inserted, you can press

the SLIP FEED button once to advance slip paper one line or hold

down SLIP FEED to feed slip paper continuously.

Indicator lights

The control panel lights provide information on printer conditions.

POWER (green)

The POWER light is on when the printer power is on.

ERROR (red)

The ERROR light is on or blinking when the printer is not ready to

print.

The ERROR light is on (not blinking) under the following

conditions:

❏

When the printer is first turned on or reset through the

interface. The light goes off as soon as the printer is initialized.

❏

When the printer cover is open.

❏

When the printer is at or near the end of a roll of paper.

The ERROR light blinks under the following conditions:

❏ When the print head is overheated. If this happens, the printer

waits until the print head cools and then resumes printing.

❏

When an error occurs.

For more information on error conditions, see Chapter 4,

“Troubleshooting.”

U925_eng.book Page 2 Thursday, July 25, 2002 9:15 AM

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Pas de commentaire

Epson TM-U925 Manuel d'utilisateur Page 30