Epson Equity I Manuel d'utilisateur télécharger pdf (Page 3)

FCC COMPLIANCE STATEMENT

FOR AMERICAN USERS

This equipment generates and uses radio frequency energy and if not installed and

used properly, that is, in strict accordance with the manufacturer’s instructions,

may cause interference to radio and television reception. It has been type tested

and found to comply with the limits for a Class B computing device in accordance

with the specifications in Subpart J of Part 15 of FCC rules, which are designed to

provide reasonable protection against such interference in a residential installa-

tion. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to radio or television recep-

tion, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following mea-

sures:

. Reorient the receiving antenna

Relocate the computer with respect to the receiver

Move the computer away from the receiver

Plug the computer into a different outlet so that computer and receiver are on

different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television

technician for additional suggestions. The user may find the following booklet

prepared by the Federal Communications Commission helpful:

“How To Identify and Resolve Radio-TV Interference Problems”

This booklet is available from the U.S. Government Printing Office, Washington

DC 20402. Stock No. 004-000-00345-4.

Note: If the interference stops, it was probably caused by the computer or its

peripheral devices. To further isolate the problem:

Disconnect the peripheral devices and their input/output cables one at a

time. If the interference stops, it is caused by either the peripheral device or

its I/O cable. These devices usually require shielded I/O cables. For Epson

peripheral devices, you can obtain the proper shielded cable from your

dealer. For non-Epson peripheral devices contact the manufacturer or

dealer for assistance.

WARNING

This equipment has been certified to comply with the limits for a Class B comput-

ing device, pursuant to Subpart J of Part 15 of FCC Rules. Only peripherals (com-

puter input/output devices, terminals, printers, etc.) certified to comply with the

Class B limits may be attached to this computer. Operation with non-certified

peripherals is likely to result in interference to radio and TV reception.

The connection of a non-shielded equipment interface cable to this equipment will

invalidate the FCC Certification of this device and may cause interference levels

which exceed the limits established by the FCC for this equipment.

. . .

111

1 2 3 4 5 6 7 8 ... 61 62

Pas de commentaire

Epson Equity I Manuel d'utilisateur Page 3