Epson PowerLite 1222 Guide de l'utilisateur télécharger pdf (Page 32)

Connecting to a Component-to-VGA Video Source

If your video source has component video ports, you can connect it to the projector using an optional

component-to-VGA video cable. Depending on your component ports, you may need to use an adapter

cable along with a component video cable.

1. Connect the component connectors to your video source's color-coded component video output

ports, usually labeled Y, Pb, Pr or Y, Cb, Cr. If you are using an adapter, connect these connectors

to your component video cable.

2. Connect the VGA connector to a Computer port on the projector.

3. Tighten the screws on the VGA connector.

If your image colors appear incorrect, you may need to change the Input Signal setting in the projector's

Signal menu.

Note: If you connected a game console, it may take a few seconds for your image to appear when you

switch to the game console's input source. To reduce the potential lag in response time to game

commands, set your game console's output format to a progressive signal of 480p or 720p. See your

game console documentation for instructions.

Parent topic: Connecting to Video Sources

Related references

Input Signal Settings - Signal Menu

Related tasks

Connecting to a Video Source for Sound

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 208 209

Pas de commentaire

Epson PowerLite 1222 Guide de l'utilisateur Page 32