Epson ELPMB30 Guide de l'utilisateur

ELPMB25User’s Guide

10Mounting Projector Plate on the ProjectorA Set the projector plate on the projector as shown in the figure, and align the screw holes on the plate w

11Mounting the Projector Plate to the Ceiling PlateAInsert the projector plate through the cutouts on the ceiling plate .B Slide the projector plate a

12C Insert the M4x10 screws into the screw holes on the projector plate and tighten them with the ball point hex wrench.Angle adjustment should be don

13If the projected image is not fit to the screen, adjust the projection position as follows.v Adjustment by the Lens Shift (for projectors with the l

14Shifting the Projected Image Up or DownAIf the screws are tightened, slightly loosen the four screws using the ball point hex wrench.B Raise or lowe

15C While supporting the projector, tighten the four screws temporarily with the ball point hex wrench.Do not tighten the screws too much at this poin

16Shifting the Projected Image to the Right or LeftAIf the screws are tightened, loosen the two screws using the ball point hex wrench.B While tighten

17Adjusting the Projected Image's Horizontal RollAIf the screws are tightened, slightly loosen the two screws using the ball point hex wrench.B A

18Install the ceiling plate cover after adjusting the installation angles as necessary if you want to coordinate the colors of the projector and the c

19C Insert the other piece for the screen side and fit it to the ceiling plate cover for the rear side.D Insert the M4x10 screws into the screw holes

2Included Items List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

3Low Profile Ceiling Mount Check the following list and confirm that you have all of the supplied items. If there is anything missing or damaged, plea

4For your safety, read the attached documents carefully to assemble and install this product correctly. Be sure to follow the safety precautions. Afte

5Carefully read the warnings in "Safety Instructions / Support and Service Guide" supplied with your projector before starting the installat

6Installing the Ceiling Plate and Ceiling Plate on the CeilingDetermine the distance to the screen and locate the mounting position before mounting

7B Remove the tape which secures the ceiling plate and the ceiling plate . Then loosen the screws (not until they come off) that secure the plates wi

8Mounting the Ceiling Plate on the Ceiling PlateAEngage the screw holes onto the screws on the rear side of the ceiling plate .Set the ceiling plate

9C Insert the M4x10 screws into the screw holes on the screen side of the ceiling plate and tighten them with the ball point hex wrench.Secure these.